Products
  • Products
  • Suppliers
  • Categories

Cooler for Pharmaceutical Water Systems

Product ID: O01-Cooler Water Systems

Send Inquiry

Sanitary tube heat exchangers are designed for point cooler

water for injection (WFI) or purified water (PW) system applications.

The use of a heat exchanger is intended for use in which water is

intermittently plotted over a period of time or at least an hour. When

the flow rate is less than 1500 Lph, it can be quickly and easily

installed. When installed in a water system, it is regarded as a subring

of the main cycle. The cooling response time is short, there is

no risk of pollution, and no maintenance is required. There are two

sizes of tube-mounted heat exchange gas, the standard operating

range: TIT HEP 01, cold water with a flow rate of 0 ~ 1000Lph,

85˚C to 40˚C @ 7˚C; TIT HEP 02, a flow of 1000 ~ 1500Lph, 85˚ C

was cooled to 40˚C @ 7˚C cold water.

Specifications
Type Lenght (m) Heat transfer area (m2) Maximum product flow (l/h) TT 311 1 0.3 1,500 TT 3151 1.5 0.5 1,000 TT 312 1 0.6 900 TT3152 1.5 1.0 700
Features
Based on an innovative tube-in-tube design, this product unit consists of three seamless tubesplaced on top of each other. There are spirals between the tubes to ensure that the space ismaintained between the tubes and turbulence is generated to achieve better heat transfer. There areno gaps or dead ends in the product channels and electrolytic polishing can be completely drainedwithout gaskets to reduce any The risk of contamination can be a complete emptying design.However, bend the three pipes 180˚ to the U-shaped elbow, and bend the three pipes with spiralsstep by step, so that there is no risk of leakage (no welds at the corners). The product enters themiddle pipe, the cooling heating medium enters the inside and the outside, and provides the mosteffective heat transfer countercurrently. It may also have a cross temperature program. The elbowabsorbs any thermal expansion, so the device is very resistant to heat fatigue. Caused by largetemperature difference during work or steam sterilization. The heat exchanger can be sold as baremetal or as a complete point-of-use cooler. This module is preferred because it is easy to install anduse directly. The module consists of pipe mounting, coating, valve device and pitot tube device.

Technical data

Max flow rate

1500 l/h

Heat transfer area

0.3-1.0 m2

Connections

Tri-clamps metric or ANSI

Material

316 L stainless steel, seamless tubes

Surface finish

Ra< 0.5 µm.  Electropolished on all product wetted parts

Welding according to

EN 287 and ASME IX

Pharma-X module

Insulation:  Armaflex

 

Cladding:  304L electropolished

Weight of module

22-46 kg

Design pressure

10 bar g

Design temperature

160 oC

Main Products

Pneumatic Actuator, Butterfly Valve, Check Valve, Sight Glass, Union, Ferrules, Clamps, BPE Pipe Fittings

Contact Detail