Products
  • Products
  • Suppliers
  • Categories

RF Admittance Switch

Product ID: SLA series

Send Inquiry
SLA series are used for Level limit detection of fine, coarse, solids, liquids and slurries, conductive or non-conductive; corrosive or non-corrosive, that have a tendency to stick and coat. For switching off conveyor when the vessel is full, to avoid overflow. For indicating on empty tank in good time to avoid production stoppage and for pump control.
Specifications
  • Electronic Insert - ICA 3000N^$Housing : Plastic, potted in epoxy resin.
  • Measuring Frequency : 500 KHz. (approximately)
  • Ambient Temperature : -20蚓 to +80蚓
  • Supply Voltage : 15 V derived from evaluation unit.
  • Output Signal : 3 to 12 V DC.
  • ^#Evaluation Unit^$Housing : Cast Aluminum, weather proof, back panel / wall mounting
  • Cable Entry : 3 Nos.
  • Max. Amb. Temp. : - 20 to +60蚓
  • ^#Evaluation Unit^$Power Consumption : 5 VA approx.
  • Mains Voltage : 230 or 110 V AC (-15 to +10%) 50Hz, 24 V AC/DC (to be specified while ordering)
  • ^#Evaluation Unit^$Fail Safe Mode : Max. or Min. field selectable
  • Indication : Red LED for Alarm
  • Green LED for Normal,
  • Yellow LED for System Fault
  • Response Time : 0.2 sec.
  • ^#Output^$One/two relay potential free c/o contacts, Rated at 6A, 230 V AC for non-inductive load.
  • ^#
  • Features
  • High Durability^$No moving parts, no mechanical wear and tear, interference free signal transmission from electronic insert to evaluation unit, system fault indication for added reliability.
  • ^#Calibration Possible from Remotely^$Evaluation unit can be installed far away from the probe. Calibration controls available in the evaluation unit.^#Fail Safe High/Low Selection ^$Reduces inventory, since the same evaluation unit can be field configured either for high or low-level fail-safe detection.
  • ^#Ignores Build Up ^$Ignores Build Up of Sticky and Conductive Material between Probe and Vessel Walls
  • Uses 3-Electrode technique with coat immunizing circuitry to create inactive region.
  • ^#Economical to Install^$Uses ordinary 3-Core cable for interconnecting the electronic insert with the evaluation unit.
  • ^#
  • Main Products

    Level Switch, Detector, Sensor, Transmitter